7-Pole 5-Wire Stator for 49cc 50cc Two-Stroke Jog Minarelli 1PE40QMB Engines

New aftermarket seven-pole stator, one piece, with pickup coil, grommet and connector. Five wires: one 3-pin plug and two separate wire connectors. Two fixing holes, 104 mm spacing. Compare plugs, pins and dimensions because multiple stator versions exist.

Listed applications and restrictions

• Suitable for most Chinese 49cc 50cc 2-stroke based on Minarelli (Jog) engines.
• Fits 2 stroke quad bikes ATV's and scooters. Similar to parts used on many 100cc CPI products, Quadzilla Buzz 50cc bikes , Aeon ATV's
• 7-coil Stator With 5 Wires. 3 Pin Plug , 2 Loose Wires, 2 Bolt holes, 104mm bolt hole spacing.
• There are multi version stator of 50cc engine, please check and compare the stator and plug with your original part to make sure this is what you want

Dimensions

• Diameter of Central Hole (Smallest): 22 mm / 0.87 inches
• Diameter of Central Hole (Greatest): 28 mm / 1.1 inches
• Outer Diameter Of Stator Poles (Greatest): 79 mm / 3.15 inches
• Mount hole spacing center to center: 104 mm / 4.08 inches
• Greatest Outer Diameter of Stator (Excluding Pickup): 117.30 mm / 4.62 inches
• Greatest Outer Diameter of Stator Plate (Including Pickup): 136.75 mm / 5.38 inches
• Plate Thickness (around outside rim): 5 mm / 0.2 inches
• Greatest Width: 136.35 mm / 5.37 inches
• Greatest Height: 34.40 mm / 1.35 inches
• Wiring Length (approx.): 435 mm / 17.13 inches

Installation notes

• Check the AC output of the stator.
• Replace any burned or corroded connectors on stator and regulator/rectifier.
• Check and repair any melted wiring.
• Use hi-temp dielectric grease on all connectors
• The stator may use a different wire color code than your original.
• All of the wires are installed in the correct order; please do not change any of the wiring configurations.
• This stator is designed as a direct plug-in replacement and should be used as such.
• When bolting stator in, always use locking compound.
• If the stator includes a pickup coil, always make sure the air gap is correct upon installation.

Begin with a fully charged battery; check battery condition before installation.

Match the listed references, application, measurements and photos to your original part before ordering.